Punching

Thin linePunchingFea­tures:

  • Fast Punch Speeds: Up to 1440 holes/minute
  • Ver­sa­tile: Hole sizes 0.075 mm to 4.76 mm, square up to .140″(3.56 mm)
  • Accu­ra­cy: posi­tion­al accu­ra­cy of ± 0.0002″ (0.005 mm)
  • Hole Ver­i­fi­ca­tion: auto­mat­ic laser optic inspec­tion of tape
  • Tool­ing changes in Min­utes: quick punch/die replace­ments

High-Speed Hole Punch­ing and Pre­ci­sion Accu­ra­cy at an Eco­nom­i­cal Price

Pacif­ic Tri­net­ics Corporation’s PT Series Punch­ing Sys­tem is specif­i­cal­ly designed for pre­ci­sion hole punch­ing in green ceram­ic tape and thin met­als.

The PT Series rep­re­sents a low-cost, high-per­for­mance solu­tion for punch­ing of holes with diam­e­ters down to 3 mils (0.075 mm) at pro­duc­tion rates of up to 1440 hits/minute. With a posi­tion­al accu­ra­cy of ± 0.0002″ (0.005 mm), tool­ing changeovers that take only min­utes and an exclu­sive auto­mat­ic laser via ver­i­fi­ca­tion sys­tem, the PT series leaps ahead of the com­pe­ti­tion.

The PT Series Punch Sys­tem offers a com­pact design with a choice of punch head con­fig­u­ra­tions. Mate­r­i­al up to 8″ (203 mm) square can be processed on indi­vid­ual frames or direct­ly on the system’s inno­v­a­tive cus­tom tool plate. The soft­ware is user-friend­ly and extreme­ly flex­i­ble. Tool­ing is of the high­est qual­i­ty and the cost is sub­stan­tial­ly low­er than that of the com­pe­ti­tion. Whether pro­to­typ­ing new designs or run­ning large pro­duc­tion vol­umes, the PT Series Punch Sys­tem meets the chal­lenge.

For more infor­ma­tion, please down­load the spec­i­fi­ca­tion sheet for this prod­uct here.

Line